You’ll find it much easier to disassemble everything every time you finish taking photos. Image via Handy Tips for Using Your DIY Backdrop Stand Save Space and Time by Avoiding Hot GlueĪ backdrop stand with the measurements above will be huge and will take up a lot of space. Make sure you do this under the pipe, not on top of it.ĭo this on both sides of the pipe to keep everything in place. Then, clip the remaining fabric to the one in front of it. When you hang the fabric over the pipe, leave a little piece behind it. If you’re shooting professionally, this might be a big obstacle. This movement might not be a problem in casual photoshoots. If you simply hang your background over the stand, it might move around too much. To make sure that your background doesn’t slide off the pipe, you can use pegs or binder clips. You’re almost done! All you need to do is hang a large piece of fabric over the highest part of the backdrop stand. Hang Your Background Fabric Over the Top Pipe to Create a Mini Studio You can use this drawing as reference for the entire backdrop stand: Image via 4. Finally, attach a 2.5-metre pipe to both elbow pipes. Put the remaining 1-metre pipes on top f the T-pipes. You’ll use the top part of your backdrop stand as a hanger for backgrounds. Create the Top Part of Your Backdrop Stand by Using the Remaining 5 Tools Without the middle PVC pipe, your backdrop stand will fall apart. This structure will strengthen the backdrop’s legs and create a balance. Then, attach one 2.5-metre pipe to the horizontal T-pipe ends. ![]() Place two T-pipes on top of the 1-metre pipes (your backdrop’s legs). Attach the 2.5m Pipe to Two T-Pipes to Create a Balanced Middle Next, you will need to place the 1m pipes into the remaining open end of the T-pipes. Then add the elbow pipes to the open end of the 50cm pipes to form feet, for extra stability. Repeat this with the other T-pipe and 50cm pieces. Take one T-pipe and place two of the 50cm pipes on either end, so they are parallel to each other. To assemble the legs, you’ll need the following tools: The first ones I used seemed sturdy at first, but they ended up wobbling and falling apart. When you look for PVC pipes, make sure they’re not wobbly. Your backdrop’s legs can’t be shaky or flexible. Create a Strong Base for Your DIY Photo Backdrop Stand ![]() In this case, you can buy a PVC cutter and make accurate cuts at home. You might not be able to find a PVC pipe with these specific lengths. Something that’s half as large as the backdrop will be enough for still life and portrait photography photos. If this isn’t what you’re looking for, you can use a shorter PVC pipe. The materials above will create a large backdrop frame that’s almost as tall as an average wall. You will be able to buy these from any hardware store. To build your DIY photo backdrop stand, you will need PVC pipes. Materials and Measurements for Your DIY Backdrop Stand
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |